You need to disable vsync like this when running glxgears:
vblank_mode=0 glxgears
For Nvidia drivers do this:
__GL_SYNC_TO_VBLANK=0 glxgears
Notice the higher than 59-60 fps results with vblank_mode=0:
ATTENTION: default value of option vblank_mode overridden by environment.
7919 frames in 5.0 seconds = 1583.704 FPS
8187 frames in 5.0 seconds = 1637.266 FPS........
This is a great way to upgrade your RAID array or move it/copy it to a new set of hard drives.
Eg. you have a current RAID 1 array on older/slower drives.
Just add at least 1 of the new drives to the array, update grub/install it and then boot into it. Then you have a transparent data migration that is fully synchronized.
mdadm --grow /dev/md126 --raid-devices 3
md127 : active raid1 sdc1........
This happened during a RAID array check:
SMART says both drives pass the test, but I'm doing a long test on them and hopefully this is not a hardware error.
Apr 3 04:22:01 remote kernel: md: syncing RAID array md2
Apr 3 04:22:01 remote kernel: md: minimum _guaranteed_ reconstruction speed: 1000 KB/sec/disc.
Apr 3 04:22:01 remote kernel: md: using maximum available idle IO bandwidth (but not more than 200000 KB/sec) for reconstruction.
Apr........
Before we start I take no responsibility for this, you should have a backup and if you make a mistake during this process you could wipe out all of your data. So backup somewhere else before starting this as a precaution, or make sure it's data you could afford to lose.
The RAID 1 Setup (Hardware Wise)
I've already setup my 2 x 1TB (Seagate) drives with identical partitions, make sure your new hard drive (the empty one) is setup like your curr........