Usually when I come across a system like this, Ijust flash the firmware to an IT mode so we get just an AHCI system with JBOD, but sometimes it is not practical for remote systems or if we fear that flashing is too risky if something goes wrong. In this case, we unfortunately have to use LSI/Broadcom proprietary CLI tools (megacli) to even make the drives visible. Step 1 - Download MegaCLI The official broadcom packages lack .deb packages and only have .rpm for........

------------------------------------- ProCurve J4903A Switch 2824 Software revision I.10.77 Copyright (C) 1991-2009 Hewlett-Packard Co. All Rights Reserved. RESTRICTED RIGHTS LEGEND Use, duplication, or disclosure by the Government is subject to restrictions........

If you move your hard drive(s) around to other computers/servers, you'll find that your eth0 keeps getting higher, the first time it will become eth1 and then eth2 etc and even higher if your server has dual or quad NICs. The reason is that udevd basically assigns eth0 tot he first NIC it finds and remembers it, if it encounters a NIC with a differentMAC, it assigns it one higher (eg. eth1). See the example below, I have eth2 now so how doI fix it?........

I closed program by program untilI found the culprit, it's baffling how the cause was Thunderbird but then again it does use a lot of memory and I have thousands of messages between dozens of mailboxes. But still I don't think this should happen and Xorg shouldn't allow this either. So for those who have mysteriously high CPUusage from Xorg start closing program by program until you find the culprit. The interesting thing is that after reloading it, the Xor........

cat /proc/user_beancounters produces the following: kmemsize 1861537 5139870 12752512 12752512 26965041 Notice the failcnt "26965041", that is for kmemsize and at first it confused me. The system had enough guaranteed and enough burst RAM available. kmemsize is a variable indepedent of that, but who cars about the explanation right, let's just make thing........

A VPS Server I had just wasn't working right, code that I migrated there just wasn't working. For example, it kept telling me the connection to the database was unsuccessful, halfway through iterating through results it already had. Then I realized it wasn't my code. Ichecked my /proc/user_beancounters and found this: cat /proc/user_beancounters Version: 2.5 uid resource held maxheld barrier limit failcnt........