Normally the first thing you would think is that you should use the host network in Docker but this loses the isolation, in that case I'd rather use LXC and a public IP or a full VM with public IP to avoid these issues. Before you Start I assume you have also ruled out any firewall issues on either end, that RTP or SIP signaling is not being blocked by either side. 1.) Key Settings in Docker/Ports Before starting, I assume you have forwarded........

Usually when I come across a system like this, Ijust flash the firmware to an IT mode so we get just an AHCI system with JBOD, but sometimes it is not practical for remote systems or if we fear that flashing is too risky if something goes wrong. In this case, we unfortunately have to use LSI/Broadcom proprietary CLI tools (megacli) to even make the drives visible. Step 1 - Download MegaCLI The official broadcom packages lack .deb packages and only have .rpm for........

#if you have nvidia make sure you install the nvidia-cuda-toolkit so hardware acceleration can be used wget http://ffmpeg.org/releases/ffmpeg-3.3.2.tar.bz2 tar -jxvf ffmpeg-3.3.2.tar.bz2 cd ffmpeg-3.3.2/ ./configure --disable-yasm install prefix /usr/local source path ........

First of all this seems to apply to many ONVIF devices Hard coded IP: 192.168.1.10 (yes not kidding no DHCP!) 00:12:12:9C:C2:00 To view RTSP stream use VLC, or openRTSP or other RTSP capable software: rtsp://192.168.1.10/user=admin_password=tlJwpbo6_channel=1_stream=0.sdp user: admin password: blank http://ip/Login.htm Uses Quicktime and is a poor quality picture and slow Cannot change pass........