Bonding is an excellent way to get both increased redundancy and throughput. It is similar to the "Network Teaming" feature in Windows. There are a few different modes but we will use mode 6, I think it's the best of both worlds, as it is not just a failover, but it provides round robin, so you will get redundancy and load balancing. So if you have a 1G single port, you will have a combined throughput of 4G at this point. Just bear in mind that the true thr........

Enable "cli" mode equivalent in JunOS cli Configure Mode configure So rather than going to the console on a Cisco switch and typing "enable" and then "conf t", the equivalent in JunOS is "cli" and "configure". How Do You Apply Changes You've Made? You can make all kinds of changes to the switch, but remember they are not........

It is not obvious but the rsync --help rsync --help|grep port --port=PORT specify double-colon alternate port number --port does not do anything at all actually for some strange reason it still uses 22 You have to specify a manual ssh command to make it work: -e 'ssh -........

This is a real pain because I had to manually unplug ethernet cables for network testing or to use an alternate network or guarantee physical access to one network segment is cut off. For some reason this happened after Ikilled dbus because it was confused and blocking packets thinking they were coming from the wrong interface since eth0 and eth1 both had the same subnet and gateway. I eventually did a "service network-manager restart" but the option was........

LSi Megaraid At first it was configured as a RAID 0, then I deleted the Virtual Disk Group. I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing. To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........

cat | grub --device-map=/dev/null Now pay close to the attention of the beginning. Type: "device (hd0) VPS.img" this is telling what hd0 will be to GRUB and we're telling it the disk image file "VPS.img" in the current directory is hd0, you can specify alternate paths and image names of course. GNU GRUB version 0.97 (640K lower / 3072K upper memory) [ Minimal BASH-li........

Basic Port ListingHopefully someone finds this useful or at least interesting. http://www.sans.org/top20/#u9 Name Port Protocol Description Small services ........

This will give you the basic info needed to browse and connect to Samba shares from the command line. From the GUI of Gnome or KDE etc, it is pretty standard and straight forward. However, I've found very little guides on how to do it from the command line and if you're like me, a nerd who prefers command line for its simplicity and for remote use, this is the way to go. First get a list of all the Samba/SMB shares on the target. smbclient -L hostname........