If you are converting a generic wifi IP camera to ethernet, it may not be that simple as many are default hard coded to a static IP of 192.168.1.168 and login info admin/admin.
From there you can login to the camera and assign it to DHCP by going to http://192.168.1.168
For security these cameras +DVR should be on a separate untagged VLAN or if possible a physically isolated non-internet connected switch/network.
The reference below is applicable to many of the r........
1.) Make sure your conf register is 0x2102
Do show version and at the very end of the output you will see the Configuration register.
show version
Configuration register is 0x2102
If the config register is not 0x2102 then enter this command:
r1#configure terminal
r1(config)#config-register 0x2102
r1(config)#end
2.) Let's Erase the NVRAM/flash........
I right clicked all applicable cells and chose "number" but that's enough.
I notice when I click the cell there is an invisible ' in front of the number:
'33.64
Calc imported my CSV and decided to add a ' in front of the numeric currency values!!!*Actually the problem occurs when you right click the cells and change the type from text to number, no matter what format you choose.
If I change it to be currency i........
This can be very annoying and CPanel doesn't seem to document it, or it's not found or made as obvious as it should be. It's always funny when I find it more difficult to work with a control panel than to do everytihng manually without CPanel or even Plesk.
So once again, the default serve path for contents is: /usr/local/apache/htdocs and this is especially applicable when accessing Apache by just an IP which is unbound to any domain at this point.........