apcupsd how to setup and monitor APC UPS units
It really seems limited in that it can mainly give you the things you would see on the physical unit such as load etc..
wget https://downloads.sourceforge.net/project/apcupsd/apcupsd%20-%20Stable/3.14.14/apcupsd-3.14.14.tar.gz?r=https%3A%2F%2Fsourceforge.net%2Fprojects%2Fapcupsd%2Ffiles%2Flatest%2Fdownload&ts=1598115866
tar -zxvf apcupsd-3.14.14.tar.gz
cd apcupsd-3.14.14
[root@somebox apcupsd-3.14.14]#
./conf........
VMWare ESXi 6.7 SSH/PowerShell CLI Commands
[root@localhost:~]
BootModuleConfig.sh echo host-ind nfcd........
pxe-32 tftp open timeout
pxe-32 tftp open timeout
The solution was to enable tftp in xinetd with "chkconfig tftp on".
See the troubleshooting below:
chkconfig --list
NetworkManager 0:off 1:off 2:off 3:off 4:off 5:off 6:off
acpid 0:off&n........
smart is not smart, it thinks a dead drive is still good
I had a dying drive that smart thought until it totally disappeared was a good drive, and actually all parameters did look fine but this system was causing my system to lockup and other bad behavior:
=== START OF INFORMATION SECTION ===
Device Model: WDC WD20EARS-00MVWB0
Serial Number: WD-WMAZ20139
Firmware Version: 50.0AB50
User Capacity: 2,000,398,934,016 bytes
Device........