On a test machine Iwas never able to access to a newly created 4th partiton. As we can see there are dev devices for everything but the 4th partition.
The normal "partprobe" or "kpartx" or kernel being told to rescan the block device didn't help (only a reboot did).
fdisk -l /dev/sda
Disk /dev/sda: 750.2 GB, 750156374016 bytes
255 heads, 63 sectors/track, 91201 cylinders
At first it was configured as a RAID 0, then I deleted the Virtual Disk Group.
I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing.
To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........
This error is annoying, in a Virtuozzo KB entry about this ip tables nat problem they say the kernel needs to be ugpraded:
The node runs 2.6.18-x kernel older than 2.6.18-028stab053.10.
NAT module does not work in container, you get "can't initialize iptables table 'nat'" error:
# iptables -t nat........
I found this article interesting, it basically says that with 2TB hard drives or larger sizes, you are more likely to encounter an unrecoverable read error. But is this just another Y2K doomsday? Don't HDD's have enough advanced hardware ECC error and read recovery to prevent this from happening?
I'm almost tempted to build a 3 x........
This was unbelievable how much the Xen kernel slows things down, keep in mind both tests were done on the hostnode, one was with the Openvz-Xen hybrid kernel and the other was just OpenVZ. You can see the performance difference is nearly 300% better when not using the Xen kernel.
OpenVZ-Xen Kernel Test Results (I was wondering what was wrong/so slow with my Core i5!)
# # # # # #&n........
You might remember my original GluserFS/OpenVZ benchmark which produced a horrible 29.8
This is the exact same system, but using the latest 2.0.8 (with some small files patch which speeds up performance) you can see it is about 25% faster.
I also haven't tuned my config files at all, but there are some settings that should increase performance on small files which I believe i........
This is very disappointing since GlusterFS markets itself as a solution to deploy VPS servers on. On the HNitself I get a Unixbench of about 360.
I'm also using an SSH tunnel to secure the communications, but even before that, things seemed very slow.
# # # # # # # #####&n........