• How to recover from dead DRBD partition/hard drive in two simple commands


    This assumes that you've at least created the correct partition for your DRBD already. Notice that I am "diskless", that's because either your DRBD partition doesn't exist/has been renamed (eg. sdb becomes sda when sdb dies and you reboot) or because that drive is really actually dead/gone. *If you need to permanently change the partition/device for your resource be sure to edit /etc/drbd.conf on both hosts and reload the config. (replace r0 with........
  • rsync ERROR: sdb2/backup.r18 failed verification -- update retained.


    ERROR: sdb2/backup.r18 failed verification -- update retained. This happened when Iwas rsyncing a dying hard drive, a lot of people seem to report this as an error with rsync itself but I don't think rsync is the issue at all. I know the source hard drive was bad, it was having all kinds of timeout, seek, hardware ECC recovered and reset errors. The only time something else could be the problem is if the data is being corrupted in transit, perhaps through........
  • Latest Articles

  • Recommended SFP+ to RJ45 Adapter Module for Switch Juniper Cisco Ubiquiti TP-Link etc...
  • Bad Power Supply Issue Story Diagnosing Troubleshooting
  • Getting started with AI (Artificial Intelligence) in Linux / Ubuntu using by deploying LLM (Language Learing Models) using Ollama LLMA
  • microk8s kubernetes how to install OpenEBS
  • Flash LSI MegaRAID 2208 to IT mode in Linux Mint/Debian/Ubuntu
  • LSI MegaRAID in Linux Ubuntu / Centos Tutorial Setup Guide megacli
  • Convert-im6.q16: attempt to perform an operation not allowed by the security policy `PDF' @ error/constitute.c/IsCoderAuthorized/413. convert-im6.q16: no images defined `pts-time.jpg' @ error/convert.c/ConvertImageCommand/3258. solution ImageMagick P
  • Apache PHP sending expires header solution cannot use cache with CDN
  • How to install virt-manager in Mint 22/Ubuntu 22
  • Infiniband Guide
  • python mysql install error: /bin/sh: 1: mysql_config: not found /bin/sh: 1: mariadb_config: not found /bin/sh: 1: mysql_config: not found mysql_config --version
  • FreePBX 17 How To Add a Trunk
  • Docker Container Onboot Policy - How to make sure a container is always running
  • FreePBX 17 How To Add Phones / Extensions and Register
  • Warning: The driver descriptor says the physical block size is 2048 bytes, but Linux says it is 512 bytes. solution
  • Cisco How To Use a Third Party SIP Phone (eg. Avaya, 3CX)
  • Cisco Unified Communication Manager (CUCM) - How To Add Phones
  • pptp / pptpd not working in DD-WRT iptables / router
  • systemd-journald high memory usage solution
  • How to Install FreePBX 17 in Linux Debian Ubuntu Mint Guide