Enable "cli" mode equivalent in JunOS
cli
Configure Mode
configure
So rather than going to the console on a Cisco switch and typing "enable" and then "conf t", the equivalent in JunOS is "cli" and "configure".
How Do You Apply Changes You've Made?
You can make all kinds of changes to the switch, but remember they are not........
Switch#show ip dhcp snooping
Switch DHCP snooping is disabled
DHCP snooping is configured on following VLANs:
1
Insertion of option 82 is enabled
circuit-id format: vlan-mod-port
remote-id format: MAC
Option 82 on untrusted port is not allowed
Verification of hwaddr field is enabled
Interface&nb........
Enter configuration console:
enable
configure terminal
This is important because if your console doesn't look like below none of the commands will work!
Switch(config)#
Save and Apply Settings
wr
Show Switch Configuration:
show run
Show Port List/Sta........