Assign way more replicas than you have of memory on all nodes and watch the Swarm crash which can easily reproduce in a small VMfor testing.
root@Deb11Docker01:~# docker ps
CONTAINER ID IMAGE COMMAND CREATED STATUS PORTS NAM........
This happened while an mdadm array was syncing, all access from writing a new blank file to opening a small .txt file was very slow:
[222117.312078] kjournald starting. Commit interval 5 seconds
[222117.685060] EXT3-fs (md0): using internal journal
[222117.685096] EXT3-fs (md0): mounted filesystem with ordered data mode
[222122.376847] kjournald starting. Commit interval 5 seconds
[222122.602825] EXT3-fs (md2): using internal jour........
The results are not bad, the Hitachi performs the same as it does in a SATA2 motherboard. However, the 2TB is much different, on a similar 2TB Toshiba I get about 198MB/s on a different motherboard vs the 2TB Hitachi which should produce similar results.
This Dell Perc 6/i is on a PCI x8 riser card and is connected to a 12-port backplane.
Adapter #0
Enclosure Device ID: 32
Slot Number: 0
Enclosure position: N/A
De........
LSi Megaraid
At first it was configured as a RAID 0, then I deleted the Virtual Disk Group.
I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing.
To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........
I've only used it on Centos, soI thought I'd make a quick Debian guide:
Install the DRBD Package
apt-get install drbd8-utils
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following packages were automatically installed and are no longer required:
libswfdec-0.8-0
Use 'apt-get autoremove' to remove them.
The following........
After an upgrade wine wouldn't open anything, not even the pre-installed notepad.
There are no wine logs and nothing is mentioned in any standard log file about why.
I finally decided to run wine from the shell and see what's going on:
wine client error:0: version mismatch 398/402.
Your wineserver binary was not upgraded correctly,
or you have an older one somewhere in your PATH.
Or maybe the wrong wineserver is still running?........