1.) Make sure your conf register is 0x2102
Do show version and at the very end of the output you will see the Configuration register.
show version
Configuration register is 0x2102
If the config register is not 0x2102 then enter this command:
r1#configure terminal
r1(config)#config-register 0x2102
r1(config)#end
2.) Let's Erase the NVRAM/flash........
This happens on some systems due to a video issue with Intel Videocards, after you see the kernel load you may see almost immediately that you get a black screen.
The following kernel parameters usually solve it:
nomodeset i915.modeset=0 xforcevesa
some people just use "nomodeset" and others use "i915.modeset=0". I think nomodeset may also do the same for each video driver so it may imply i915.modeset=0 anyway but I am not sure.........