Kubernetes Easy Beginners Tutorial/Architecture Guide Kubernetes is known as container orchestration and we should start at explaining the container part of it. A Container is what runs the actual application and based on an Image, and are more comparable to something like an LXC Container, Virtuozzo/OpenVZ using the Linux Kernel Namespaces feature. Containers run these images as independent, isolated operating environments under the O........

It is fairly simple to use once you know how to use it. However, the tricky thing is that by default it doesn't seem to be active or listen on any interface on manually specified. How To Install ifplugd First we install ifplugd sudo apt install ifplugd Let's enable it on our desired device(s) vi /etc/default/ifplugd set this line as so:........

Cisco's CUCM (Cisco Unified Communication Manager) is a system that combines voice, video, data and mobile products into a single unified management suite. At its core, the CUCMis like a "Super PBX" that controls the flow of all communications through an organization even single or multiple site deployments. Cisco's CUCMmakes communication more effective and simple through centralized management and unification of communications resources.........

It sounds like this is corrected in later versions of the OpenVZ kernel but Iam not sure, it may also be that a much newer kernel is needed and Centos may not have a recent enough kernel. *Debain 7.0 however does work fine as a temporary fix or work around. Debian 8 OpenVZ no IP and networking not working: lo Link encap:Local Loopback  ........

If you move your hard drive(s) around to other computers/servers, you'll find that your eth0 keeps getting higher, the first time it will become eth1 and then eth2 etc and even higher if your server has dual or quad NICs. The reason is that udevd basically assigns eth0 tot he first NIC it finds and remembers it, if it encounters a NIC with a differentMAC, it assigns it one higher (eg. eth1). See the example below, I have eth2 now so how doI fix it?........

NOTICE[11389]: rtp.c:1808 ast_rtp_read: Unknown RTP codec 100 received from I've found that trying several times may work, but I also read changing your Sipura VOIP adapter settings as follows helps (but it still fails for me sometimes): In adapter change the following under SIP/Advanced Codec to G711a from G711u Passthru Method from: NSE to ReINVITE FAX CED Detect Enable: Yes FAX CNG Detect........

Remember to replace "eth0" with your NIC device although usually it will be eth0. Replace 192.168.1.1 with your default gateway, remember you can also add multiple gateways by adding a second/different default gateway. route Kernel IP routing table Destination Gateway Genmask&nb........