DRBD Errors Caused By Physical Corruption

In a RAID array I had a have periodically lost a drive here and there over the past several months.  I was always able to readd and resync without losing data.  However at some point it looks like some minor corruption happened and this makes DRBD unhappy.

Using fsck did not help either.

 


Dec 19 06:01:45 storageboxtest4 kernel: [19005.945890] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22184379, block=88735771
Dec 19 06:01:45 storageboxtest4 kernel: [19005.946084] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22184380, block=88735771
Dec 19 06:01:45 storageboxtest4 kernel: [19005.946289] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22184381, block=88735771
Dec 19 06:01:46 storageboxtest4 kernel: [19006.903899] block drbd0: helper command: /sbin/drbdadm pri-on-incon-degr minor-0 exit code 0 (0x0)
Dec 19 06:01:46 storageboxtest4 kernel: [19006.903918] block drbd0: helper command: /sbin/drbdadm local-io-error minor-0
Dec 19 06:01:46 storageboxtest4 kernel: [19006.908202] Power Off
Dec 19 06:01:46 storageboxtest4 kernel: [19006.910016] md: md125: recovery interrupted.
Dec 19 06:01:47 storageboxtest4 kernel: [19007.715470] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22840092, block=91357233
Dec 19 06:01:47 storageboxtest4 kernel: [19007.715789] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22840092, block=91357233
Dec 19 06:01:47 storageboxtest4 kernel: [19007.785375] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22840094, block=91357233
Dec 19 06:01:47 storageboxtest4 kernel: [19007.785705] EXT3-fs error (device drbd0): ext3_get_inode_loc: unable to read inode block - inode=22840094, block=91357233
Dec 19 13:35:55 storageboxtest4 kernel: imklog 5.8.10, log source = /proc/kmsg started.

Just a simple dd test gives back an io error near the end of the array:

dd: reading `/dev/drbd0': Input/output error


Tags:

drbd, errors, corruptionin, raid, array, periodically, readd, resync, corruption, fsck, dec, storageboxtest, kernel, ext, fs, _get_inode_loc, unable, inode, helper, sbin, drbdadm, pri, incon, degr, io, md, interrupted, imklog, proc, kmsg, dd, dev, input, output,

Latest Articles

  • FreePBX 17 How To Add a Trunk
  • Docker Container Onboot Policy - How to make sure a container is always running
  • FreePBX 17 How To Add Phones / Extensions and Register
  • Warning: The driver descriptor says the physical block size is 2048 bytes, but Linux says it is 512 bytes. solution
  • Cisco How To Use a Third Party SIP Phone (eg. Avaya, 3CX)
  • Cisco Unified Communication Manager (CUCM) - How To Add Phones
  • pptp / pptpd not working in DD-WRT iptables / router
  • systemd-journald high memory usage solution
  • How to Install FreePBX 17 in Linux Debian Ubuntu Mint Guide
  • How To Install Cisco's CUCM (Cisco Unified Communication Manager) 12 Guide
  • Linux Ubuntu Redhat How To Extract Images from PDF
  • Linux and Windows Dual Boot Issue NIC Won't work After Booting Windows
  • Cisco CME How To Enable ACD hunt groups
  • How to install gns3 on Linux Ubuntu Mint
  • How to convert audio for Asterisk .wav format
  • Using Cisco CME Router with Asterisk as a dial-peer
  • Cisco CME How To Configure SIP Trunk VOIP
  • Virtualbox host Only Network Error Failed to save host network interface parameter - Cannot change gateway IP of host only network
  • Cisco CME and C7200 Router Testing and Learning Environment on Ubuntu 20+ Setup Tutorial Guide
  • Abusive IP ranges blacklist