This normally happens when you interrupt the install of Ceph: pveceph install update available package list start installation Reading package lists... Done Building dependency tree... Done Reading state information... Done gdisk is already the newest version (1.0.6-1.1). ceph-common is already the newest version (15.2.15-pve1). ceph-fuse is already the newest version (15.2.15-pve1). Some package........

The reason for doing this is that the installer doesn't seem to work properly for LUKS and the server installer doesn't even support LUKS anymore. When you use the GUI install on Desktop for LUKS it won't boot and will just hang after you enter your password. So the only reliable way is to do it ourselves. 1.) Make a default minimal install of Ubuntu 2.) Have a secondary disk on the server or VM. 3.)........

Done on Centos 7.3 very important as clearly based on older guides it was a lot easier and more simpler! Hint do not use grub2-install! If you have trouble booting after this check this CentOS mdadm RAID booting/fixing guide. One huge caveat if you are an oldschool user or sysadmin who has avoided UEFIbooting The nor........

1.) Replicate the number of partitions in your new drives. gdisk /dev/sda gdisk /dev/sdb I created 3 partitions of the same same size. partition #1: +1G (/boot) partition #2: +60G (swap) partition #3: rest of it (/) #note if you are using GPT/gdisk you need to create separate a partition at least 1MB in size (in my case I would a 4th partition and mark it type ef02).........

sudo fdisk /dev/sdh WARNING: GPT (GUID Partition Table) detected on '/dev/sdh'! The util fdisk doesn't support GPT. Use GNU Parted. WARNING: The size of this disk is 8.0 TB (8001563221504 bytes). DOS partition table format can not be used on drives for volumes larger than (2199023255040 bytes) for 512-byte sectors. Use parted(1) and GUID partition table format (GPT). The device presents a l........

grub> root (hd0,0) root (hd0,0) Filesystem type is ext2fs, partition type 0xfd grub> setup (hd0) setup (hd0) But if you do: root (hd1,0) setup (hd1) it does work, I think hd0/sda had a GPT partition that was not removed properly (what I did was just dd bs=512 count=1 the partition table from another drive since the partition table should be identical). Checking if "/boot/grub/........