Bonding is an excellent way to get both increased redundancy and throughput. It is similar to the "Network Teaming" feature in Windows.
There are a few different modes but we will use mode 6, I think it's the best of both worlds, as it is not just a failover, but it provides round robin, so you will get redundancy and load balancing. So if you have a 1G single port, you will have a combined throughput of 4G at this point. Just bear in mind that the true thr........
Yes you have that right, the network service in RHEL8 / CentOS 8 / Rocky Linux / Alma Linux no longer exists. So there is no more systemctl restart network
You can restart NetworkManager but it doesn't have the same effect or ifup/ifdown on all interfaces.
Generally if NetworkManager is installed you will want to restart it or it won't apply the settings from ifcfg.
systemctl restart NetworkManager
To repl........
It is fairly simple to use once you know how to use it. However, the tricky thing is that by default it doesn't seem to be active or listen on any interface on manually specified.
How To Install ifplugd
First we install ifplugd
sudo apt install ifplugd
Let's enable it on our desired device(s)
vi /etc/default/ifplugd
set this line as so:........
Having a network bridge allows you to bridge traffic under multiple devices so they can talk natively without using any special routing, iptables/firewall or other trickery.
To create your bridge you need the bridge-utils package for brctl and if you want to do things like bridge VMs that run on a tap device you will need the uml-utilities which provides "tunctl".
1.) Install the utilities to make our bridge
sudo apt-get i........
The only solution after trying many suggestions was to simply restart the "vz" service (definitely not preferable).
Even doing an ifdown and ifup for venet0 did not help.
ifup venet0
Bringing up interface venet0:
Configuring interface venet0:
net.ipv4.conf.venet0.send_redirects = 0
RTNETLINK answers: Network is down
Some errors from log:
CPT ERR: d2dc60........
service vz start
Starting OpenVZ: failed to load module vzmon [FAILED]
vzmon: Unknown symbol ve_snmp_proc_init
vzmon: Unknown symbol addrconf_sysctl_free
vzmon: Unknown symbol ve_ndisc_init
vzmon: Unknown symbol addrconf_ifdown
vzmon: Unknown symbol ip6_frag_cleanup
vzmon: Unknown symbol fini_ve_route6........
service vz start
Starting OpenVZ: failed to load module vzmon [FAILED]
vzmon: Unknown symbol ve_snmp_proc_init
vzmon: Unknown symbol addrconf_sysctl_free
vzmon: Unknown symbol ve_ndisc_init
vzmon: Unknown symbol addrconf_ifdown
vzmon: Unknown symbol ip6_frag_cleanup
vzmon: Unknown symbol fini_ve_route6
........