The only solution after trying many suggestions was to simply restart the "vz" service (definitely not preferable).
Even doing an ifdown and ifup for venet0 did not help.
ifup venet0
Bringing up interface venet0:
Configuring interface venet0:
net.ipv4.conf.venet0.send_redirects = 0
RTNETLINK answers: Network is down
Some errors from log:
CPT ERR: d2dc60........
If you get that message it means you have inserted the adapter or device incorrectly. In my case the adapter needed to be at the rear end of the pins and it caused this message.
Do not ignore this message as it may appear to work but you will get errors and in reality your chip will not be erased or programmed even if it appears like it is working.........
LSi Megaraid
At first it was configured as a RAID 0, then I deleted the Virtual Disk Group.
I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing.
To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........
I wanted to Import/Use a .vmdk hard disk image file from VMWare. Generally you can just "point" VirtualBox to it and use it and it will work but I found an exception.
One of my Centos 4.4 x64 images wouldn't boot. I had two copies, an older one and the newer one. The older one booted as normal (once I changed the VirtualBox driver to IDE from SATA). The newer one stopped at the "GRUB loading" message no matter what I tried.
As far as........