You need to use the Samsung driver but specify it as a CLP-360 (this is what I used for my CLP365) and incidentally most of these units look identical on the outside on inside (I've been buying whatever the latest C300 and now 400 unit for years which all seem the same with slightly different features that I never use).
Once again try specifying earlier models and revisions if the printer doesn't print (it will say it's been sent to the printer bu........
The first is a dual CPU AMD Opteron 2373EE (4 cores x 2) and I think it did bad because it has some old 250GB SATAs which can only do about 65MB/s max sequential reads. I think it should have blown away the second (AMD X4 640 Quad Core).
[root@fs12home unixbench-4.1.0-wht-2]# ./Run
make: Entering directory `/root/unixbench-4.1.0-wht-2'
Checking distribution of files
This was unbelievable how much the Xen kernel slows things down, keep in mind both tests were done on the hostnode, one was with the Openvz-Xen hybrid kernel and the other was just OpenVZ. You can see the performance difference is nearly 300% better when not using the Xen kernel.
OpenVZ-Xen Kernel Test Results (I was wondering what was wrong/so slow with my Core i5!)
# # # # # #&n........
You might remember my original GluserFS/OpenVZ benchmark which produced a horrible 29.8
This is the exact same system, but using the latest 2.0.8 (with some small files patch which speeds up performance) you can see it is about 25% faster.
I also haven't tuned my config files at all, but there are some settings that should increase performance on small files which I believe i........
This is very disappointing since GlusterFS markets itself as a solution to deploy VPS servers on. On the HNitself I get a Unixbench of about 360.
I'm also using an SSH tunnel to secure the communications, but even before that, things seemed very slow.
# # # # # # # #####&n........