• redis requirements


    sysctl vm.overcommit_memory=1 echo never > /sys/kernel/mm/transparent_hugepage/enabled echo 511 > /proc/sys/net/core/somaxconn 1:M 26 Nov 2023 21:34:33.840 # WARNING: The TCP backlog setting of 511 cannot be enforced because /proc/sys/net/core/somaxconn is set to the lower value of 128. 1:M 26 Nov 2023 21:34:33.840 # Server initialized 1:M 26 Nov 2023 21:34:33.840 # WARNING overcommit_memory is set to 0! Background sa........
  • Cisco Switch / Router How To Restore Factory Default Settings


    1.) Make sure your conf register is 0x2102 Do show version and at the very end of the output you will see the Configuration register. show version Configuration register is 0x2102 If the config register is not 0x2102 then enter this command: r1#configure terminal r1(config)#config-register 0x2102 r1(config)#end 2.) Let's Erase the NVRAM/flash........
  • Cisco 2900 3900 Router Password Reset How To Reset Enable Password


    It is a bit different and annoying here for these types of routers/models as you need to physically remove the CF (Compact Flash) and only then, will it enter ROMMON mode (Ctrl + Pause remotely over the console will not do it for us). This means you cannot do this remotely, or at least not without the help of a remote/physical helper. Step 1.) Power off, router and remove CF Disk Slot#2 Go to the router and remove the slot#2 cover uses your hand or it may help to use a........
  • Loaded: masked (Reason: Unit hostapd.service is masked.) Solution in Linux Debian Mint Ubuntu


    If you are getting this error from systemctl "Loaded: masked (Reason: Unit hostapd.service is masked.)" we need to unmask the service. Solution systemctl unmask hostapd Removed /etc/systemd/system/hostapd.service. It's fixed root@routerOS:/var/log# systemctl start hostapd root@routerOS:/var/log# systemctl status hostapd ● hostapd.service - Access point and authentication server for Wi-Fi and Ethern........
  • i915 nouveau Nvidia GPU not starting lightdm Xorg failing solution for Could not determine valid watermarks for inherited state


    It may appear to be an Xorg or lightdm/gdm/mdm error but in reality for many users with this issue, it's a driver conflict and issue. I had a system that had two GPUs, an Intel and Nvidia GPU. The only thing that got it working was to remove the nouveau driver and blacklist it so it never came back, then the Intel GPU works fine without these issues. Solution sudo rmmod nouveau add nouveau/other driver to blacklist edit th........
  • LightDM Mint Ubuntu Debian won't start errors Nvidia Graphics


    This error implies that there may be an issue with Xorg or maybe your NVIDIA GPU cannot start or initialize: 35 laptop kernel: [ 2031.857704] nvidia: loading out-of-tree module taints kernel. 35 laptop kernel: [ 2031.857724] nvidia: module license 'NVIDIA' taints kernel. 35 laptop kernel: [ 2031.857725] Disabling lock debugging due to kernel taint 35 laptop kernel: [ 2031.873280] nvidia: module verification failed: signature a........
  • Nvidia Linux Card not working due to LSI 9200/SAS2008 IRQ conflict


    At first my BIOS said the card may not work right because there is no more option ROM space. I disabled the Option ROM for both LSI 1068 and 2008 chipsets, Network Boot ROM and most other PCI slots, Serial Port, etc... and the message went away but the card still does not work properly. But it still cannot initialize the card properly(does not work): [ 33.943272] NVRM: This PCI I/O region assigned to your NVIDIA device is invalid:........
  • Avocent 8020 KVM Java Icedtea Viewer


    This command in Debian/Ubuntu/Mint will get everything need installed for most Java based KVM viewers: sudo apt install icedtea-netx The following additional packages will be installed: ca-certificates-java icedtea-netx-common openjdk-8-jre openjdk-8-jre-headless It seems every other updated version of Java or Icedtea breaks things and I will save the frustration of Java for another post.........
  • Lost connection to MySQL server during query [2013]


    This happened while trying to delete several thousand users from phpBB and basically corrupted the innoDB tables. InnoDB: Page lsn 3 881164362, low 4 bytes of lsn at page end 881164362 InnoDB: Page number (if stored to page already) 86920, InnoDB: space id (if created with >= MySQL-4.1.1 and stored already) 0 InnoDB: Page may be an index page where index id is 700 InnoDB: (index "tid_post_time" of table "phpBBdb2005"."phpbb3_p........
  • drbd 8.3 hard drive failure recovery example


    drbd 8.3 hard drive failure recovery drbdadm attach r0 DRBD module version: 8.3.10 userland version: 8.3.8 you should upgrade your drbd tools! 0: Failure: (119) No valid meta-data signature found. ==> Use 'drbdadm create-md res' to initialize meta-data area. ........
  • How to recover from dead DRBD partition/hard drive in two simple commands


    This assumes that you've at least created the correct partition for your DRBD already. Notice that I am "diskless", that's because either your DRBD partition doesn't exist/has been renamed (eg. sdb becomes sda when sdb dies and you reboot) or because that drive is really actually dead/gone. *If you need to permanently change the partition/device for your resource be sure to edit /etc/drbd.conf on both hosts and reload the config. (replace r0 with........
  • Linux - mptbase/MPT Fusion LSI Logic Error mptbase: ioc0: ERROR - didn't initialize properly! (-1)


    kernel 2.6.27.54 Fusion MPT base driver 3.04.07 Copyright (c) 1999-2008 LSI Corporation Fusion MPT SPI Host driver 3.04.07 mptbase: ioc0: Initiating bringup mptbase: ioc0: WARNING - Unexpected doorbell active! mptbase: ioc0: ERROR - Doorbell ACK timeout (count=4999), IntStatus=80000001! mptbase: ioc0: ERROR - Diagnostic reset FAILED! (102h) mptbase: ioc0: WARNING - NOT READY! mptbase: ioc0: ERROR - didn't initialize proper........
  • Ubuntu/Debian DRBD 8.0 Setup Guide


    I've only used it on Centos, soI thought I'd make a quick Debian guide: Install the DRBD Package apt-get install drbd8-utils Reading package lists... Done Building dependency tree Reading state information... Done The following packages were automatically installed and are no longer required: libswfdec-0.8-0 Use 'apt-get autoremove' to remove them. The following........
  • DRBD WFConnection Problem/Solution


    This has stumped me a few times because I keep forgetting that Centos 5.5 comes with a default iptables configuration that ends up blocking DRBD traffic,I tried all the normal things and couldn't understand why I couldn't make my normal DRBD config work. So if you have WFConnection problems and have tried the normal "mailing list" fixes, check your firewall status first! Both Nodes Say the Following: version: 8.3.8 (api:88/prot........
  • Latest Articles

  • Recommended SFP+ to RJ45 Adapter Module for Switch Juniper Cisco Ubiquiti TP-Link etc...
  • Bad Power Supply Issue Story Diagnosing Troubleshooting
  • Getting started with AI (Artificial Intelligence) in Linux / Ubuntu using by deploying LLM (Language Learing Models) using Ollama LLMA
  • microk8s kubernetes how to install OpenEBS
  • Flash LSI MegaRAID 2208 to IT mode in Linux Mint/Debian/Ubuntu
  • LSI MegaRAID in Linux Ubuntu / Centos Tutorial Setup Guide megacli
  • Convert-im6.q16: attempt to perform an operation not allowed by the security policy `PDF' @ error/constitute.c/IsCoderAuthorized/413. convert-im6.q16: no images defined `pts-time.jpg' @ error/convert.c/ConvertImageCommand/3258. solution ImageMagick P
  • Apache PHP sending expires header solution cannot use cache with CDN
  • How to install virt-manager in Mint 22/Ubuntu 22
  • Infiniband Guide
  • python mysql install error: /bin/sh: 1: mysql_config: not found /bin/sh: 1: mariadb_config: not found /bin/sh: 1: mysql_config: not found mysql_config --version
  • FreePBX 17 How To Add a Trunk
  • Docker Container Onboot Policy - How to make sure a container is always running
  • FreePBX 17 How To Add Phones / Extensions and Register
  • Warning: The driver descriptor says the physical block size is 2048 bytes, but Linux says it is 512 bytes. solution
  • Cisco How To Use a Third Party SIP Phone (eg. Avaya, 3CX)
  • Cisco Unified Communication Manager (CUCM) - How To Add Phones
  • pptp / pptpd not working in DD-WRT iptables / router
  • systemd-journald high memory usage solution
  • How to Install FreePBX 17 in Linux Debian Ubuntu Mint Guide