1.) Make sure your conf register is 0x2102
Do show version and at the very end of the output you will see the Configuration register.
show version
Configuration register is 0x2102
If the config register is not 0x2102 then enter this command:
r1#configure terminal
r1(config)#config-register 0x2102
r1(config)#end
2.) Let's Erase the NVRAM/flash........
This works on the 2000 and 3000 series generally.
*The easy way is to just hold the mode button for 10+ seconds.
The full/proper way is below:
1.) Either power on the unit and hold the "mode" button or hold the "mode" button until you see the below:
00:04:08: %SYS-7-NV_BLOCK_INIT: Initalized the geometry of nvram
00:04:08: %EXPRESS_SETUP-6-CONFIG_IS_RESET: The configur........
1.) Flash directly to this file:
http://tomato.groov.pl/download/K26RT-N/build5x-132-EN/Linksys%20E-series/tomato-E2500-NVRAM60K-1.28.RT-N5x-MIPSR2-132-Max.zip
*I was never able to get the larger "Mega" file to work, at least not initially so I recommend the file above.
To enable 5ghz I had to do the "Clear NVRAM" Option before it was shown.
2.) Or if you don't need 5ghz (most devices do not support it and cannot........