pulseaudio issue on QEMU/KVM guest VM when microphone is replugged/unplugged pulseaudio: pa_threaded_mainloop_lock failed pulseaudio: Reason: Invalid argument
Here is the scenario, you are using QEMU/KVM and are using something like the AC97 sound driver to pass the host audio to the guest via pulseaudio. This is useful because you can transparently pass your mic input from the host which means you can mute your microphone from the host, which prevents the guest from receiving any mic input even if unmuted.
Mute / Unmute Fix
This issue also seems to happen even if you press the mute button on the microphone and then unmute,........
OpenVPN cannot ping remote IP routing loop issue after connecting
Sometimes if you have a very basic configuration OpenVPN on the client side for some reason sends all traffic to the OpenVPN server IP through the tun0 which is of course impossible and creates a block or routing loop.
This is because you need to use your normal ISP/LANgateway to hit the OpenVPN server if it is remote/offsite as is usually the case. So if you are connected to the OpenVPN through say a tun0 device and your routing is set to connect to the OpenVPN&nbs........
MySQLD Server shutdown remotely unexpectedly
170110 5:35:23 [Note] /usr/libexec/mysqld: Normal shutdown
170110 5:35:23 [Note] Event Scheduler: Purging the queue. 0 events
170110 5:35:23 InnoDB: Starting shutdown...
170110 5:35:24 InnoDB: Shutdown completed; log sequence number 0 12765401
170110 5:35:24 [Note] /usr/libexec/mysqld: Shutdown complete
170110 05:35:24 mysqld_safe mysqld from pid file /var/run/mysqld/mysqld.pid ended........
Asterisk iptables block bruteforce attacks howto with fail2ban
yum -y install fail2ban
vi /etc/fail2ban/jail.conf
[asterisk-tcp]
enabled = true
filter = asterisk
action = iptables-multiport[name=asterisk-tcp, port="5060,5061", protocol=tcp]
sendmail-whois[name=Asterisk, dest=you@example.com, sender=fail2ban@example.com]
logpath = /var/log/asterisk/messages
maxret........
LSI MegaRAID Adventures, Guide and HowTo
LSi Megaraid
At first it was configured as a RAID 0, then I deleted the Virtual Disk Group.
I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing.
To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........