I am mainly used to the enterprise where most connections are deployed by some "normal" kind of fiber eg SFP+, QSFP+, SFP28, QSFP28 and those modules are almost fool proof, run cool and are reliable. Like most normal admin users, I like to use my own hardware for routing and switching rather than the often poor equipment provided by the ISP, especially when you have enterprise hardware that will be more reliable. The normal path is that you would just take the fiber op........

This should work for most console ports of other manufacturers too. It is a quick and simple method for emegencies or deploying a few appliances/devices in a non-standard environment or small environment. However, if this is a route thing, or the equipment is not physically close to you, it would be best to use some sort of "Terminal" server which is an IP connected switch with several serial ports built-in for this purpose. Normally they accessible by web/........

A lot of older devices either support telnet or very old SSH keyx algorithms which are insecure and disabled by all newer/modern SSH clients for security reasons. However, sometimes you may be on a LAN via VPNor some other secured network or for whatever reason, absolutely, need to connect to this device and sometimes old/embedded devices may not be possible to update to a newer SSH server. If you run into this you may be using a modern/newer SSH client and get thi........

Just a quick note and warning is that if you are testing to see if EFIPXE booting works on a VM, MAKE SURE it actually works. For example Iinitially tested using my Distro's QEMU 2.5+dfsg-5ubuntu10.46 and ovmf BIOS firmware (OVMF supports EFI). However, I found on old versions of QEMU (like 2.5), EFIbooting with GRUB NEVER works so it may appear that you have made a mistake when everything is fine when you boot a physi........

Enable "cli" mode equivalent in JunOS cli Configure Mode configure So rather than going to the console on a Cisco switch and typing "enable" and then "conf t", the equivalent in JunOS is "cli" and "configure". How Do You Apply Changes You've Made? You can make all kinds of changes to the switch, but remember they are not........