Linux Mint offers an easy and painless upgrade path through the last 3 versions, which means no more reinstalling to stay current with the latest version.
The only catch is that you need the latest of each version, so for 18, you need 18.3 before you can go to 19, and then 19.3 (or latest), until you go to 20. However, it's really a small price to pay and on the machines we've tested, the upgrade went seamlessly each time (although sometimes video drivers/custom kernel modules l........
For some reason, perhaps you don't want to run a daemon or let Letsencrypt have access to your production server.
There is a way to use it like a normal CSR/CA setup in manual mode.
./letsencrypt-auto certonly --manual -d realtechtalk.com - www.realtechtalk.com
Eventually you will get prompted to create a certain path and file with certain data:
Create a file containing just this data:
The key thing here is to know the actual partition that is encrypted.
Often in Linux Mint's installer that ends up being partition 5 or /dev/sda5
sudo cryptsetup luksOpen /dev/sda5 anynamehere
You will then be prompted for your irrecoverable passphrase:
Enter passphrase for /dev/sda5:
If all goes well it won't say anything further. If it says ""No key available with this passphr........
Some of the cheaper or newer SSL suppliers will require this to work properly (otherwise you may be prompted that the cert is invalid when it's not the case but it will certainly scare off your users!).
In the Apache vhost conf for the domain here is what you add:
Here is a full example of an SSL Vhost config in Apache using a CA Certificate file
Iwill start by saying I think I know what caused this boot-time error on Linux Mint but should also apply to Debian and Ubuntu.
I changed my BIOS time to several hours in the past to match the current time, but this caused Linux to think there were incorrect filesystem times.
The problem is that it seems when you hit this I am not sure what is happening, it doesn't seem to be doing fsck and hangs without prompting the user.
What I have found is that........
At first it was configured as a RAID 0, then I deleted the Virtual Disk Group.
I thought both drives would be shown and detected in Linux as sda and sdb but it actually shows nothing.
To make them work you have to hit Ctrl+R before the system boots (when prompted) and create a Virtual Disk Group. In my case I created each one as RAID 0 (with a single drive only) as I just wanted JBOD but there is no such option or default in these Dell Pe........
As much of a computer nerd as Iam, I'm usually a late adopter to technology for a few reasons. Ifeel most new hyped technologies and electronics are mainly fads, and I'm also cheap.
Adopting later means you avoid the bugs, kinks and most importantly pay the lowest price, that's me being cheap again :)
I never read much about the iPhone but Isaw all the hype around it and until recently I wasn't a big fan of anything Apple until a few years ago I realize........
This will give you the basic info needed to browse and connect to Samba shares from the command line. From the GUI of Gnome or KDE etc, it is pretty standard and straight forward. However, I've found very little guides on how to do it from the command line and if you're like me, a nerd who prefers command line for its simplicity and for remote use, this is the way to go.
First get a list of all the Samba/SMB shares on the target.
smbclient -L hostname........