Disk /dev/sdb: 15.22 GiB, 16336814080 bytes, 31907840 sectors Disk model: SD/MMC Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0x00000000 The fdisk output is above and below is the error you may get when trying to use the d........

Here is an easy way to restore things if you have the starting point and size of each partition using fdisk: In this example we pretend that /dev/sda was wiped out, but the running system still has the info in /sys/class/block/sda Go into each partition and record the "start" and "size" hostdev@box /sys/class/block/sda/sda1 $ cat start 2048 hostdev@box /sys/class/block/sda/sd........

It took a lot of fiddling to make a Huion Kamvas 13 Pro work in Linux but it simple once you know what to do. Don't bother searching as it is unlkely there is a guide out there that will actually make your tablet work. It mainly comes down to the fact that the hid_uclogic kernel module is buggy or doesn't support MANYof these wacom based/Huion tablets properly. What was happening with me is that Ihad the Kamvas 13 Huion setup as a secondary screen/monitor.&nb........

I find that the default settings for the radeon driver that is applied to most AMD cards is horrible. For example by default TearFree is not enabled and it causes videos to have some kind of square artifacts. Here are the settings I have found most suitable for AMD cards: You need to create file in the following path and restart Xorg or your computer to apply it: *Beware that making a mistake here will possibly make your computer........

Use fdisk on your USB drive to create a bootable NTFS partition (in my case /dev/sdb): sudo fdisk /dev/sdb Welcome to fdisk (util-linux 2.27.1). Changes will remain in memory only, until you decide to write them. Be careful before using the write command. Command (m for help): n Partition type p primary (0 primary, 0 extended, 4 free)........

This is all controlled by /etc/issue You can basically enter anything in there that you like, but there are preset variables that are mentioned at the end of the page that discuss this. Some examples of /etc/issue: Centos 7: S Kernel r on an m Ubuntu 16.04: Ubuntu 16.04.6 LTS n l You can also insert any of t........

What you need to do if you have taken a dd or real raw image dump of a hard disk: VBoxManage convertdd windows2019-eval-template.img windows2019.vdi --format VDI The .img is the raw dd dump and the .vdi is the output file. --format VDIspecifies to output to .vdi format If you are in a pinch you can always use qemu-kvm binary and manually specify the .img as your disk and i........

On a test machine Iwas never able to access to a newly created 4th partiton. As we can see there are dev devices for everything but the 4th partition. The normal "partprobe" or "kpartx" or kernel being told to rescan the block device didn't help (only a reboot did). fdisk -l /dev/sda Disk /dev/sda: 750.2 GB, 750156374016 bytes 255 heads, 63 sectors/track, 91201 cylinders Units........

sudo apt-get install libcurl4-openssl-dev git build-essential autotools-dev autoconf libcurl3 sudo apt-get install libcurl4-gnutls-dev git clone https://github.com/wolf9466/cpuminer-multi sudo apt-get install cmake libpthread-* libmicrohttpd-dev libssl-dev libhwloc-dev git clone https://github.com/fireice-uk/xmr-stak-cpu.git make install cd bin chmod +x xmr-stak-cpu ./xmr-stak -O xmr........

sudo mkdir -p /etc/X11/xorg.conf.d/ sudo vi /etc/X11/xorg.conf.d/20-intel.conf On newer Ubuntu / Mint / Debian systems the file would go in: /usr/share/X11/xorg.conf.d/20-intel.conf Type "i" and enter the following: Section "Device" Identifier "Intel Graphics" Driver&n........

sudo fdisk /dev/sdh WARNING: GPT (GUID Partition Table) detected on '/dev/sdh'! The util fdisk doesn't support GPT. Use GNU Parted. WARNING: The size of this disk is 8.0 TB (8001563221504 bytes). DOS partition table format can not be used on drives for volumes larger than (2199023255040 bytes) for 512-byte sectors. Use parted(1) and GUID partition table format (GPT). The device presents a l........

grub> root (hd0,0) root (hd0,0) Filesystem type is ext2fs, partition type 0xfd grub> setup (hd0) setup (hd0) But if you do: root (hd1,0) setup (hd1) it does work, I think hd0/sda had a GPT partition that was not removed properly (what I did was just dd bs=512 count=1 the partition table from another drive since the partition table should be identical). Checking if "/boot/grub/........

Here is the scenario you or a client have a remote machine that was installed as a standard/default minimal Centos 6.x machine on a single disk with LVM for whatever reason. Often many people do not know how to install it to a RAID array so it is common to have this problem and why reinstall if you don't need to? In some cases on a remote system you can't easily reinstall without physical or KVM access. So in this case you add a second physical or disk or already ha........

./configure ./configure: cannot locate gcc 3.x. please install it or specify with --qemu-cc yum -y install gcc make ./configure ./configure: cannot locate gcc 3.x. please install it or specify with --qemu-cc yum -y install compat-gcc-* ./configure Error: Could not find alsa Make sure to have the alsa libs and headers installed. yum -y install alsa-lib-devel ./configure........

The results are not bad, the Hitachi performs the same as it does in a SATA2 motherboard. However, the 2TB is much different, on a similar 2TB Toshiba I get about 198MB/s on a different motherboard vs the 2TB Hitachi which should produce similar results. This Dell Perc 6/i is on a PCI x8 riser card and is connected to a 12-port backplane. Adapter #0 Enclosure Device ID: 32 Slot Number: 0 Enclosure position: N/A De........

This was partitioned as a single 32GB VFAT but when I inserted it into the phone it said that it can't read it and now here is how the partition table looks. Interestingly enough the data works and reads fine from the computer still. Disk /dev/sdb1: 32.1 GB, 32085360640 bytes 64 heads, 32 sectors/track, 30598 cylinders, total 62666720 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum........

This booting error is because the Xen PV guest image uses the Xen kernel, this is not compatible with anything but a host running a Xen kernel. I did a kpartx -av virtual.img and then it created some partitions that showed up in fdisk. I mounted it and did a chroot into it and removed the xen kernel and installed a normal kernel but Xen still shows the same kernel in Grub (only the Xen one). This is strange but it seems like this Xen PV guest has some sort of hidden or........

mdadm --manage /dev/md1 --add /dev/sdb1 mdadm: metadata format 00.90 unknown, ignored. mdadm: metadata format 00.90 unknown, ignored. mdadm: metadata format 00.90 unknown, ignored. mdadm: /dev/sdb1 not large enough to join array md1's first primary member /dev/sda3 has 57394 cylinders while the /dev/sdb1 has 57393 (1 less cylinder) which is why it won't work. fdisk -l /dev/sda3 Disk /dev/sda3: 47........

There's no partial WD EARS alignment fix: I had data on /dev/sda3 and /dev/sdb3 (RAID1) so I couldn't edit that one. I thought I'd be smart and try fixing the first two partitions so I set the first one starting at sector 2048 and then +8 for the second partition. This has really slowed the performance down worse than it ever was! Disk /dev/sda: 2000.4 GB, 2000398934016 bytes 255 heads, 63 sectors/track, 243201 cylinders, tot........

Here is a RAID 1 partition (500GB Seagate & 2TB WD): Sequential Reads File Blk Num Avg Maximum Lat%&nbs........

This is a great way to use your ftp server space, for example on your web hosting account (althoughI believe many hosts don't allow storage like this), but if you have a VPS/Dedicated Server etc.., this would be perfect. Imagine how easy it is to work with an ftp account that you can just mount as a normal partition or directory in Linux, it would be great for backups etc.. Name curlftpfs - mount a ftp host as a local directory Synopsis........

I'm using Ubuntu 8.04 but anyone using older kernels will find this may apply to them. My Intel graphics are very slow with the default Xorg settings but by using "EXA" acceleration, scrolling down windows of text becomes pretty snappy. Just edit /etc/X11/xorg.conf Section "Device" Identifier "Configured Video Device" &nb........

I was creating a RAID array and got this error: mdadm: /dev/sda1 is too small: 0K mdadm: create aborted Of course sda1 is not too small, both partitions sda1 and sdb1 are identical in size: Disk /dev/sda: 2000.3 GB, 2000398934016 bytes 255 heads, 63 sectors/track, 243201 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk identifier: 0x00000000 Device Boot Sta........

The dmg format is silly and annoying to work with, why couldn't Apple stick with the .iso standard? Anyway, there's an excellent Linux and Windows based tool to convert it back to a normal .iso Image called dmg2iso I'll only cover theLinux version although the Windows pre-built binary works the same way. Download dmg2iso here for free (from the author's website) It's just silly and doesn't make sense that Ubuntu doe........